Messages

1

General Mach Discussion / Re: Steppers and constant contour under Mach 3?

« on: September 07, 2010, 11:33:27 PM »

Even steppers? Not just servos?

2

General Mach Discussion / Steppers and constant contour under Mach 3?

« on: September 07, 2010, 02:18:12 PM »

I am looking at upgrading my stepper driven system (currently Ahha), does Mach 3 make the steppers constant contour instead of stopping at every line (jerky slower movement) like the old Ahha does? I want to upgrade to Mach 3 so I can run Windows and have a modern computer with networking and a USB port. Also the old Ahha Artisan didn't constant contour very well. Maybe I'm spoiled from our large servo driven system (Fagor).

3

General Mach Discussion / Re: Mach3 and AhHa break out board

« on: September 07, 2010, 02:13:22 PM »

I have the same issue- my cable from the computer is a 37 pin cable. Any info on your conversion yet? Where might I get new drivers to fit the ahha power supply?