Hello Guest it is March 29, 2024, 03:57:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jamied

Pages: « 1 2 3
21
General Mach Discussion / Re: any advice welcome
« on: September 19, 2013, 01:17:38 PM »
Had a look at those CSMIO controllers Hood ,  they do look ideal and as you say have the options to ad more i/o connections , just need to look into what's involved in the tool change operation and what I need to control to get it to work along with spindle orientation as I think there's some type of spindle position sensor along with the encoder on the top of the motor , but defiantly lots to get my head around 

22
General Mach Discussion / Re: any advice welcome
« on: September 18, 2013, 04:56:19 PM »
Thanks guys , I didn't think about PLC that makes sense , did do a little with PLC,s a few years back so will have to refresh myself , will have a look at CSMIO/IP-A Controller Hood as I'm undecided on what controller to use   

23
General Mach Discussion / any advice welcome
« on: September 18, 2013, 10:15:20 AM »
Hi , im looking at retrofitting my Hurco BMC with mach3 , i have done a few machines before but only a knee mill, lathe  and plasma cutter, this is a whole new ball game , im thinking of retaining the Yasakawa 10bb1bf drives if at all possible and getting mach to control them as I beleave there + or _ 10v also retaining the spindle drive as well if I can , the nightmare will be the ATC and spindle orientation , would appreciate any advice if anyone has ever used these drives ? or had any experience with any of the things I may come across

regards

Jamie

Pages: « 1 2 3