Hello Guest it is January 16, 2022, 10:42:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jamied

Pages: 1
CS-Lab / outputs 4 and 5 on CSMIO
« on: October 15, 2013, 03:46:50 PM »
just setting up mu ports and pins settings for my VFD  have configured the spindle CW to output 4 and CCW to output 5 and set the pins in the output signals to (output 4 port 10 pin 12) and (output 5 to port 10 pin 13 ) both enabled , but its not switching on the relay on the CSMIO ?? if i set the CW or CCW spindle settings to either 1,2,or 3 outputs they all energies but not 4 or 5 ?? what am i doing wrong ?

General Mach Discussion / servo drives and ecoders
« on: October 06, 2013, 02:03:25 PM »
in using Omron R7M  drives to convert my Hurco and need to connect the encoders , the encoders on the HURCO motors are 6 pairs plus 0v and 5v , but there are feedback encoders fitted to the ball screws on each axis that have A+,A-,B+,B-,GZ+ and GZ- so im thinking of using these connected to my servo drives , the drives have the A,B and a Z connections but also have a S+ and S- ? do these need to be used ? if so what are they for ? appreciate any advice


General Mach Discussion / servo drive plugs
« on: September 27, 2013, 08:43:15 AM »
can any one identify these plugs on this servo drive , I need to get hold of some plugs to fit them , anyone know of anywhere to buy them , there are 14 pin encoder ones and 36 pin on the  input connector



General Mach Discussion / what am I missing!
« on: September 27, 2013, 03:40:06 AM »
if anyone can cast an eye over the attached drawings and tell me what im missing , I have linked pin 6-20, I have no pin 7 so have linked pin 21 to pin 20 , linked pin 8 to 22 for forward run , and am feeding pins 3 and 4 with my 0 to 10v  , have tried the alarm reset linked and un-linked but still get no drive , im obviously wrong somewhere but any help would be appreciated ,

General Mach Discussion / any advice welcome
« on: September 18, 2013, 10:15:20 AM »
Hi , im looking at retrofitting my Hurco BMC with mach3 , i have done a few machines before but only a knee mill, lathe  and plasma cutter, this is a whole new ball game , im thinking of retaining the Yasakawa 10bb1bf drives if at all possible and getting mach to control them as I beleave there + or _ 10v also retaining the spindle drive as well if I can , the nightmare will be the ATC and spindle orientation , would appreciate any advice if anyone has ever used these drives ? or had any experience with any of the things I may come across



Pages: 1