Hello Guest it is January 18, 2022, 11:09:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - 123srd

Pages: 1
General Mach Discussion / Re: E-stop problem (new set-up)
« on: January 07, 2011, 06:42:44 PM »
Hi Hood,  My last thought was correct, Mach 3 recognises this input via pin 5.  The C10 user manual doesn't mention any input # / parallel port conversion. The C10 board has a female socket, so I'm using an old Belkin data cable with a male plug on both ends. I've just checked pin to pin with a multimeter and the Belkin cable is crossed and not pin to pin like a standard DB25 cable.  I feel a bit silly now for not checking this sooner.... and having a background in automation!!
Many thanks for your offer of assistance,  I'm sure to post help requests again when I get into software limits and fixtures.
All the best, Sean

General Mach Discussion / Re: E-stop problem (new set-up)
« on: January 07, 2011, 05:37:47 PM »
Hi Hood,  I'm using a normally closed switch, so passing +5v back to the C10 board. I have set the E-stop entry in ports and pins to port 2 / pin 10.  The C10 board for this input is set to pull down, so when the E-stop is activated Mach 3 will "see"  0V at the input which should activate the E-stop condition.  This should operate as fail safe by using a NC switch if the cable is damaged.
As I mentioned, I can see the input being activated in the diagnostics page and I have tried different settings in Mach 3 and the C10 board. I'm assuming here that input 10 on the C10 pcb relates to pin 10 on the parallel port?
Any ideas you might have would be gratefully received!!
Regards, Sean

General Mach Discussion / E-stop problem (new set-up)
« on: January 07, 2011, 12:48:07 AM »
Hi,  I have a CNC4PC C10 parallel interface card which is plugged into my second parallel port (port 2). I have connected the E-stop into pin 10, switching +5 V and the pin 10 input set to pull down on the pcb.  I can see the input working on the Mach 3 diagnostics screen, the lower 8th from right LED flashing on and off ,"input signals current state". The signal is set to active high and the signal is enabled in ports and pins. The E-stop works fine when testing without hardware inputs and set to active low.
Am I missing something here !!!

Pages: 1