Hello Guest it is January 15, 2021, 12:50:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - P.C.S.

Pages: 1
General Mach Discussion / Re: Mach 3 Charge pump circuit layout, problem
« on: August 12, 2010, 12:56:56 PM »
Hi Tweaky,

thanks for your reply. It would make a difference, but the capacitor in the circuit is 0.01µF. Just a typo in the PCB layout.


Hi guys,

my name is Phil, I'm a Mach3 user for about 2 years now. It controls my CNC gantry style router.

In the moment I try to improve safety on my machine, for example by installing a charge pump circuit. I made a pcb of the charge pump circuit by M. Freimanis from the Mach download area, but it does not work properly. I would appreciate any help in the following topic:


Take car

General Mach Discussion / Mach 3 Charge pump circuit layout, problem
« on: August 12, 2010, 10:02:42 AM »
Hi guys,

my name is Phil and I'm working on a PCB for the mach3 charge pump circuit following the circuit by Mariss Freimanis in the support download area.

I attached a picture of my layout for the circuit no. 2. It only switches my relays properly, when the voltage connected to +5V DC is lowered to about 4V DC.
The only modification I made is a IRF1404 mosfet. IC pin connections like in the datasheet of the HEF4538.

I could install a +4V voltage regulator, but this does not solve the basic problem with the circuit. I would appreciate any help or advice very much.

Thanks in advance.

Pages: 1