Hello Guest it is March 29, 2020, 11:18:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Thom2000

Pages: « 1 2 3
21
General Mach Discussion / loading mach3 drivers /windows 7/ 32bit
« on: March 01, 2016, 12:21:58 PM »
Hello,
I can not load the drivers on an older pc running win7/32bit  After installing mach3 the set-up wiz says no drivers installed.
Any ideas would be very helpful.
Thank you.

22
General Mach Discussion / Re: Modifying a post processor
« on: January 13, 2016, 12:07:40 PM »
Thank you very much.
I've been wanting to change a post processor I wrote 7 years ago and couldn't remember that.
Worked great.

23
General Mach Discussion / Re: Modifying a post processor
« on: January 13, 2016, 10:59:40 AM »
Thanks,
I have tried that with no success. Th problem is although the file name now says .pst, the progam itself is still a TXT.
So lazycam does not see it as a post processor selection.
Brian explained to me  how to save it as a .pst file and I can not remember. Too much saw dust I guess.

24
General Mach Discussion / Modifying a post processor
« on: January 12, 2016, 11:13:03 PM »
Hi folks,
I am trying to modify a post processor.The problem I'm having is saving it as a .pst extension.
I open in notepad and I beieve that is the probem. It only saves as .txt.
any ideas?
Thank you in advance.
Thom

Pages: « 1 2 3