Hello Guest it is March 28, 2024, 05:58:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Thom2000

Pages: « 1 2 3 »
11
General Mach Discussion / Re: ZBrain writing
« on: April 14, 2017, 08:12:51 PM »
Oh nevermind. It was too easy.

12
General Mach Discussion / ZBrain writing
« on: April 14, 2017, 07:51:16 PM »
Hello Folks,
I need to write a brain that would activate a relay when the Z location is less than Z0.0
Any help would be much appreciated.
Thank you in advance

13
General Mach Discussion / Re: USB to 25 pin break out board
« on: March 20, 2017, 12:52:43 PM »
Thank you for the info.

14
General Mach Discussion / USB to 25 pin break out board
« on: March 20, 2017, 11:39:30 AM »
The PC has a USB port.
The machine controller has a 25 pin break-out board  (C10).
Is it possible to run mach3 using a simple USB to 25pin lp1 cable?
I'm guessing there is more to it.

15
General Mach Discussion / Re: Brain writing
« on: March 01, 2017, 08:03:08 PM »
Never mind, got it.

16
General Mach Discussion / Brain writing
« on: March 01, 2017, 05:02:59 PM »
Hello ,
I need to write a simple brain to trigger an output(1) using the Imput1 LED (821)  .

At the prompt to :

Do Nothing
Immediate   Compare  ETC
I'm not sure what action is needed to indicate the LED is on/off.
Any help with this would be greatly appreciated.
 I've watched videos and still am lost.
Thanks.

17
General Mach Discussion / Pin-out signal to activate button function
« on: August 18, 2016, 05:49:32 PM »
Hello Group,
I would like to activate the Single Block button in Mach3 using a 12v input signal.
Is this possible using a brain ?
Thank you in advance.
TC

18
General Mach Discussion / Re: loading mach3 drivers /windows 7/ 32bit
« on: March 01, 2016, 12:50:52 PM »
 I did that too and it says no drivers detected.
I have 5 of these pcs. And they say the same thing.

19
General Mach Discussion / Re: loading mach3 drivers /windows 7/ 32bit
« on: March 01, 2016, 12:40:55 PM »
I may be wrong.
It has a LP1 printer port .

20
General Mach Discussion / Re: loading mach3 drivers /windows 7/ 32bit
« on: March 01, 2016, 12:39:58 PM »
Yes it does.

Pages: « 1 2 3 »