Hello Guest it is March 28, 2024, 06:29:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - apollonono

Pages: « 1 2 3 4 5 6 »
41
NC Pod / Re: Anyone tried the new plugin yet ?
« on: May 18, 2007, 07:52:42 PM »
"2,022" new versions were found.
I am a secret whether it worked enough. ???

42
Screen designer tips and tutorials / A general question
« on: May 01, 2007, 11:31:32 PM »
A general question.
In the end back, indication of GUI becomes very slow after having started MACH.
I am restored when I reboot a computer.
Is there a method to return without rebooting?

43
NC Pod / Re: Anyone tried the new plugin yet ?
« on: April 23, 2007, 12:41:07 AM »
"2,020" new versions were found.
Did somebody try to test it?
Did it work?

44
NC Pod / Re: NC Pod ship date? Buy beta now or wait?
« on: April 13, 2007, 09:50:12 AM »
I imported PCI boards of USB2.0.
I prohibited old support from BIOS.
A ncpod board does not still work.
Is there the other information?
Please report the movement situation of all.

45
NC Pod / Re: Anyone tried the new plugin yet ?
« on: April 13, 2007, 09:42:20 AM »
"2,019" new versions were found.
I was going to introduce it, but it was not accepted.
By a version of a board, will not you work?

46
NC Pod / Re: New POD user has some questions
« on: April 10, 2007, 01:27:40 AM »
About a connector.
Firstly I am connected to a prepared connector with direct Handa.
There is a method to substitute in  (I use it for computers) for single headers of 100mil.

47
NC Pod / Re: Anyone tried the new plugin yet ?
« on: April 04, 2007, 06:18:37 AM »
I catch the information that may be a problem.
However, I cannot clarify this.
I think that I want the problem to improve by his hand.

48
NC Pod / Re: NC Pod Ports and Pins questions
« on: March 13, 2007, 09:39:10 AM »

49
NC Pod / Re: New ncPod plugin available - 9th March
« on: March 12, 2007, 09:59:11 PM »
@appeared! .
I waited; new "ncPOD Firmware Installer for Mach3 Users (Firmware Version 2018 )"
http://ncpod.oemtech.com/downloads/ncPOD%20Firmware%20Updater%202018.zip
However, "USB1.1" does not seem to be yet usable.

50
NC Pod / Re: NC Pod ship date? Buy beta now or wait?
« on: February 23, 2007, 07:37:07 AM »
I investigated it.
About 50% computers cannot use "USB2.0".
iThere is not a driver in bridge and Win98 of an old typejWhen the firm ware that "USB1.1" is supported arrives, I think that I am activated more.

Pages: « 1 2 3 4 5 6 »