Messages

21

NC Pod / Re: what version of Mach3 do I need

« on: January 16, 2008, 08:38:55 AM »

I cannot understand English well.
You may have already tried it.
Only on the display of the computer, did you give test of the empty mawashi driving?
Can you mention the almost all of the connection diagram?

22

NC Pod / Re: how to change number of pulses in NCPOD

« on: January 06, 2008, 07:40:31 PM »

Hello.
Which place was there your "ncPOD.ini" in?
Did you carry out motor tuning of "MACH3?"
Are these two objects effective both?

23

NC Pod / Re: how to change number of pulses in NCPOD

« on: January 06, 2008, 08:24:17 AM »

Hi.
The next contents may not be precise.
Did you watch "ncPOD.ini" somewhere?

24

NC Pod / Re: LIMIT SWICHES

« on: January 06, 2008, 08:09:48 AM »

Hello.
Did you try the next panel?
http://ncpod.oemtech.com/downloads/ncPod%20Basic%20Control%20Panel%201.0.0.0.zip
Thus where is the method to connect it with MACH3 supported if I work?
OEMTEC or artsoft.

25

NC Pod / Re: Welcome To The NC Pod Development, Discussion and Support Topic

« on: December 29, 2007, 09:49:41 PM »

Hello, all which I am troubled with without working.
I found the "USB analysis" (SnoopyPro) next.
I examined "a USB driver" with this.
"The ncPUD driver" has three (Vid_16c0&Pid_056f) and cannot delete them.
The deletion of the "registry" (Vid_16c0&Pid_056f) of "Windows" is not admitted.
Did everybody try this?

26

NC Pod / Re: Welcome To The NC Pod Development, Discussion and Support Topic

« on: October 07, 2007, 11:44:47 PM »

About 1 month seems to be delayed,

I took the report that I revised for one part from him.
Some his plans seem to be late, but I endure still it and wait for completion.

27

NC Pod / Re: NC Pod Ports and Pins questions

« on: September 20, 2007, 07:01:53 AM »

I do not understand English well.
I win a number item by item and can write it intelligibly?

It is hard to understand the next contents.
"What should the Port and Pin configuration for the Motor outputs be set to?"

28

NC Pod / Re: PWM to Digital??

« on: August 19, 2007, 11:06:06 PM »

ncPOD uses inside function of MPU by the function of the port.
Therefore, there is the case that it is difficult to change an assignment.
A and C are PT23.
EDBF is PB4567.
I am similar and am equivalent, and I am posted.
That I assign PWM besides A and C is imagined when I suppose C to be a reservation if the change of the firm ware is necessary.

29

NC Pod / Re: PWM to Digital??

« on: August 19, 2007, 12:48:55 AM »

I use A for PWM and cannot use B,D,E,F for the output?

30

NC Pod / Re: PWM to Digital??

« on: August 18, 2007, 11:54:04 AM »

The image is hard to be small, but is readable?