8
« on: May 10, 2015, 11:33:44 PM »
If it was noise then I would have expected it to cut a different thread each time, I am able to shut the machine down rerun the code and have it perfectly ghost cut the original thread, I wouldnt have thought noise would have allowed this to happen.
As stated already, the LED on the C3 board is pulsing with each rotation, the LED on the input pin of the C32 is also pulsing, based on these two indicators I am not seeing any false triggers or intermittent pulsing, HOWEVER on the diagnostics screen of SS I am not seeing consistent pulsing of the input.
Can someone confirm that on there SS diagnostics screen they are seeing consistent pulsing? perhaps debouncing?
thx