Hello Guest it is February 29, 2024, 10:44:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sped1530

Pages: 1
1
General Mach Discussion / Re: motor input missed up
« on: December 20, 2012, 06:46:36 PM »
Sorry I need to explain a little more. I have a g540 and was having trouble with the dirrection the x was going. So I messed with the pins and now I have it all missed up.

http://www.flickr.com/photos/42236663@N05/8291760983/in/photostream/lightbox/

http://www.flickr.com/photos/42236663@N05/8292817512/in/photostream/lightbox/

If someone could post there pin settings I would appreciate it.

Dave

2
General Mach Discussion / motor input missed up
« on: December 20, 2012, 06:02:16 PM »
I tried to fix my mach3 but screwed it up now it's cutting letters in reverse.  

3
General Mach Discussion / Re: z not raising enough after cutting
« on: October 12, 2011, 01:30:35 PM »
so I need to try setting my safe z higher?

4
General Mach Discussion / z not raising enough after cutting
« on: October 12, 2011, 11:49:48 AM »
I set my vcarve  to .3 and my mach3 safe z to .2 . It cuts the letter then move to the next letter and carves a .05 grove as it move to the next cut. 

Anyone ever have that problem?

Dave

Pages: 1