1
dspMC/IP Motion Controller / Re: dspmc with mach3 - output problem
« on: August 13, 2010, 04:30:45 PM »
Hi!
I solved my problem. In tab "Port and Pins" >> "Spindle Setup" I set the port for my connection to dsp module.
Then I create a brain which contain open contact "Mist On" and other important for my machine.
I solved my problem. In tab "Port and Pins" >> "Spindle Setup" I set the port for my connection to dsp module.
Then I create a brain which contain open contact "Mist On" and other important for my machine.