1
General Mach Discussion / V carving using Mach 3
« on: May 06, 2011, 12:42:56 PM »
I really hope that someone here can help me get this set up right.
I have a problem with v carving and I think that it may be the mach software. If i try to v carve a name for a sign I get real a cut that takes a considerable amount of time and jerky motion out of the machine . I have tried every thing that I know and I have never been happy .
I am cutting on a shopbot machine with an acension control box using mach 3 R3.042.040
windows xp sp3 1 gig ram
Is every one else doing v carving that they are happy with?
Is there a check list of settings that need to be verified?
I did have better results using the old shopbot software even though it was slow and noisey.
Any help would be helpful
I have a problem with v carving and I think that it may be the mach software. If i try to v carve a name for a sign I get real a cut that takes a considerable amount of time and jerky motion out of the machine . I have tried every thing that I know and I have never been happy .
I am cutting on a shopbot machine with an acension control box using mach 3 R3.042.040
windows xp sp3 1 gig ram
Is every one else doing v carving that they are happy with?
Is there a check list of settings that need to be verified?
I did have better results using the old shopbot software even though it was slow and noisey.
Any help would be helpful