1
General Mach Discussion / testing outputs on breakout card
« on: July 22, 2011, 06:48:46 AM »
Under section 5.3.8 of the mach3 manual it covers testing.
It tells you to go to the diagnostic screen
it is then possible to test each input by shorting to ground each input pin
on the breakout card and an "led" on the screen lights up.
That great for the inputs.
Is it possible to test each of the outputs one by one by tweaking something on the screen.
I have an led and resistor on each of the outputs on the breakout card.
john f
It tells you to go to the diagnostic screen
it is then possible to test each input by shorting to ground each input pin
on the breakout card and an "led" on the screen lights up.
That great for the inputs.
Is it possible to test each of the outputs one by one by tweaking something on the screen.
I have an led and resistor on each of the outputs on the breakout card.
john f