Topics

1

General Mach Discussion / External speed button?

« on: January 30, 2013, 09:33:41 AM »

Is it possible to put a external button, potentiometer, to set or adjust F speed?
In my setup i don't have time to go for the mouse to adjust speed.

2

General Mach Discussion / Need help

« on: June 03, 2010, 07:05:04 AM »

I just started using mach3. Everything works great but if i run a g code program and when that is done i use my mpg to jog, and i start my program again or if i do a manual data imput the machin does a G0 to the point where i started jogging from and then starts the program from there!?
Is there a fix for this or am i the only one hwo has this problem? I am using a external servo driver, kanalog + kflop from dynomotion.com