Hello Guest it is March 28, 2024, 07:38:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Sastrom

Pages: 1
1
General Mach Discussion / External speed button?
« on: January 30, 2013, 09:33:41 AM »
Is it possible to put a external button, potentiometer, to set or adjust F speed?
In my setup i don't have time to go for the mouse to adjust speed.

2
General Mach Discussion / Re: Need help
« on: July 15, 2010, 11:46:25 AM »
Yes this solved my problem. Thanx

3
General Mach Discussion / Re: Need help
« on: June 05, 2010, 03:24:13 AM »
If i run a program
" G01 X10 Y0 F200
G01 X0 F200"
 it goes to X0 Y0 and then i jog with my mpg to X100. If i the run my prog again the machin fast travels to X0 before it starts movement to X10 Y0.
This only happens with my MPG not with keyboard jogg

4
General Mach Discussion / Need help
« on: June 03, 2010, 07:05:04 AM »
I just started using mach3. Everything works great but if i run a g code program and when that is done i use my mpg to jog, and i start my program again or if i do a manual data imput the machin does a G0 to the point where i started jogging from and then starts the program from there!?
Is there a fix for this or am i the only one hwo has this problem? I am using a external servo driver, kanalog + kflop from dynomotion.com

Pages: 1