Messages

31

General Mach Discussion / Multiple Head Router

« on: June 15, 2010, 02:34:41 AM »

Hello Everyone

We are almost finish with our Machine Retrofit. The Machine is a router with 5 high speed spindle and 5 Z Axis Which are independently controlled by Electronic Servo Drive (totally independent from Mach 3) . The Axis and tool head is being activated by an Output. Which I have use M61 to M67 = to turn output 1 to output 7 and M60 will turn output 1 to output 7. When you call M61 the z lowers the Motor and is ready to cut.

My question is which is the best way to offset the tools
I Have attached photo of the Machine and a Program that use to run on the old controller

Thanks
Renato

32

dspMC/IP Motion Controller / Vital System DSMP Controller

« on: June 08, 2010, 10:53:39 PM »

Hello Everyone,

FYI
There is a new firmware upgrade From VitalSytem that will enables you to change Static IP Address of the DSPMC controller just in case it conflicts with other IP address.

Cheers
Renato

33

VB and the development of wizards / Re: Frequency out

« on: June 08, 2010, 08:52:59 AM »

Hi Manuel,

Do you still have a spare Analog ouput, If Yes you can buy a analog to frequency converter. I am currently using one on our Pulse Ferranti Laser. I can't remember the brand.  I will check it tomorrow.

cheers
renato