Topics

1

G-Code, CAD, and CAM discussions / G code Sub routine

« on: May 20, 2010, 06:17:52 PM »

Hi everybody. i don't know if it's the right place but i need some help with G-Code. I want to make a code that, for example, drill in one place and then drill again 20 microns to the side and then 20 micron again until it reach 3 mm. Basically i need to make a code with incremental of 20 micron to the side and then down, left and up again to make a square. I a simple thing but i try over and over again and i can't do it.

Thank you