1
General Mach Discussion / Losing y position inconsistently
« on: November 03, 2010, 04:05:42 PM »
Every now and then at the start of a toolpath the machine will move to the center and then go and cut a shifted distance off in the y position. It's not a machine problem and I start the machine very slowly because I thougt the initial movement may have made it skip a step. The machine can move fast during long cuts with no problem it is just when starting a new cut. I can run the same path several times with no problems then I get it again. This is very frustrating and makes a lot of scrap. Last night I ran a cut for 1 1/2hrs then started a profile path that started off and ruined it. The computer running the machine is dedicated and has no internet or screen saver just Mach 3. Any ideas would be greatly appreciated.