1
General Mach Discussion / G-code limit in Mach3
« on: November 13, 2018, 03:22:55 PM »
Hi,
I've being using Mach3 for several year now, and lately I'm trying my hand at cutting 3d images.
I have a project right now on-going, I cut the roughthing toolpath took (about 7 hours) and I am trying to cut the finish toolpath (about 70 hours, 1/32 tapered bit about 6.7 million line of code).
I load the file, takes a while for it to load, when I try to start cycle, Mach3 is not responding.
My Pc is stand alone, running windows XP.
Hence my question is there a limit to number a g-code line Mach3 will accept and if so how can I split the lines in notepad to stop and start if I divide the lines in several parts?
Any help would be appreciated
T.Y.
I've being using Mach3 for several year now, and lately I'm trying my hand at cutting 3d images.
I have a project right now on-going, I cut the roughthing toolpath took (about 7 hours) and I am trying to cut the finish toolpath (about 70 hours, 1/32 tapered bit about 6.7 million line of code).
I load the file, takes a while for it to load, when I try to start cycle, Mach3 is not responding.
My Pc is stand alone, running windows XP.
Hence my question is there a limit to number a g-code line Mach3 will accept and if so how can I split the lines in notepad to stop and start if I divide the lines in several parts?
Any help would be appreciated
T.Y.