Messages

21

General Mach Discussion / Re: erratic motor motion

« on: November 12, 2017, 11:21:10 PM »

In the device manager, is your computer set up as Standard, or ACPI?   If the latter try changing it to Standard... that is what I did when I used to run my CNC from a laptop.

Marsha

22

General Mach Discussion / Re: Mach e-stops on Program Load

« on: December 09, 2010, 12:49:11 PM »

If the "Use Watchdogs" is set in "General Configuration",  loading or Regen-ing,  can sometimes trip the "Driver watchdog" causing a e-stop... (At least on the laptop I use to cut with)

Marsha