Hello Guest it is September 26, 2020, 06:32:34 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MarshaJ847

Pages: « 1 2
11
General Mach Discussion / Re: Locked motors
« on: August 22, 2019, 01:35:59 PM »
Here are my settings:
Step Pulse: 0
Dir Puls: 0
Step Pulse of 0 microseconds won't do anything...
I think the default is usually
Step Pulse: 2
Dir Puls: 2

Marsha

12
General Mach Discussion / Re: No X, Y or Z movement after last use.
« on: December 21, 2017, 12:12:56 PM »
worked fine until it returned zero at the end of the cut. /quote]

Check on any hard or soft limit settings that may have been and remain tripped after the 'return to zero'

13
General Mach Discussion / Re: erratic motor motion
« on: November 12, 2017, 11:21:10 PM »
In the device manager, is your computer set up as Standard, or ACPI?   If the latter try changing it to Standard... that is what I did when I used to run my CNC from a laptop.

Marsha

14
General Mach Discussion / Re: Mach e-stops on Program Load
« on: December 09, 2010, 12:49:11 PM »
If the "Use Watchdogs" is set in "General Configuration",  loading or Regen-ing,  can sometimes trip the "Driver watchdog" causing a e-stop... (At least on the laptop I use to cut with)

Marsha

Pages: « 1 2