Hello Guest it is April 25, 2024, 11:51:09 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TramAlot

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »
81
General Mach Discussion / Re: What Do You Think?
« on: October 14, 2010, 10:22:54 AM »
 http://www.tigerdirect.com/applications/SearchTools/item-details.asp?EdpNo=4959294&CatId=1422 serial

http://www.tigerdirect.com/applications/SearchTools/item-details.asp?EdpNo=4624354&CatId=512

both work well.

82
General Mach Discussion / Re: Output voltage problem?
« on: October 13, 2010, 12:45:15 PM »
could be done. I don't have anything hooked up directly so I'm probally talking out of turn. could be the windings just shorted.

how much amperage is it pulling?

83
General Mach Discussion / Re: Output voltage problem?
« on: October 13, 2010, 12:34:08 PM »
sounds like the new computer puts out less current, energy star, I'd try a relaY that needs less current

just an idea?

84
Share Your GCode / Re: Looking for Ferrari Emblem G code or DXF file
« on: October 11, 2010, 07:10:01 PM »
do you have meshCAM and somthing like CorelDraw. graphic to gecode is not very hard with those two.

this may help too

http://www.logotypes.ru/list_e.asp?cat=A

85
General Mach Discussion / Re: best monitor size
« on: October 09, 2010, 02:22:08 PM »
23.5 Touch acer from tiger direct. 335 + 15 sh. last month. works great for my old eyes.........

good luk

86
G-Code, CAD, and CAM discussions / Re: Z direction problem
« on: October 07, 2010, 07:23:24 PM »
Is it possible you hooked the motor wires up wrong?

87
General Mach Discussion / Re: What Do You Think?
« on: October 07, 2010, 11:54:25 AM »
sweet, I love the roooooooooom  :)

88
General Mach Discussion / Re: What Do You Think?
« on: October 07, 2010, 10:50:59 AM »
I use tiger direct bare bones kits. 250 . os I get from ebay

89
Newfangled Solutions Mach3 Wizards / Re: Lathe wizards collection
« on: October 03, 2010, 12:31:13 PM »
lazy turn and corel is what I use.

most wizards for lathes just thread and straight turn paths

90
General Mach Discussion / Re: Mach did again!
« on: September 29, 2010, 10:01:37 AM »
have you tried a differnt controler, mabe the cooling fan took a dump

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »