Hello Guest it is August 09, 2022, 03:27:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TramAlot

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »
41
General Mach Discussion / Re: Lazycam posts wrong g-code? SO LOST!!
« on: May 19, 2011, 01:02:12 AM »
could the machine be in metric and the drawing in inches?

42
"it's real easy.' ^$$@*%^#*#$^%*@#(*(%%^&@ FOR U MAYBE :)

THANK YOU AGAIN

43
General Mach Discussion / Re: CNC4PC??
« on: May 09, 2011, 03:44:51 PM »
no rant 2 me, sounds true to me

leave divided and concur to the osamas/obamas

44
General Mach Discussion / Re: CNC4PC??
« on: May 09, 2011, 02:19:51 PM »
still working for me, their hardware is great also

45
thats: g1 X 1(moves x to 1 at current feed rate)

46
I mean may, I only know that it is set once and not ment to be changed after. The g20/g21 comands will switch the machine between mm and inches once you get it set up.

You could try entering this for a test

G20(inch mode)
G90(absolut positioning)
F5(feed rate)
X 1(moves x to 1)

47
Do you have onboard pport or a pci card? I would check the bios fist

48


At the top of the screen, config then select native units. You will need to recheck all your motor setting I think.

49
General Mach Discussion / Re: 4th Axis Rotary Table!!!
« on: May 05, 2011, 10:59:20 AM »
The sherlines backlash is adjustable if ever needed also.

50
The DeskProto Hobby-lice‚Äčnse is back,

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »