Messages

11

General Mach Discussion / Re: Homing Problem

« on: May 06, 2010, 02:49:36 PM »

Here is my XML

12

General Mach Discussion / Re: Homing Problem

« on: May 06, 2010, 02:30:03 PM »

The Z axis zeros but the Y axis never zeros, and the X never has a chance.

13

General Mach Discussion / Homing Problem

« on: May 06, 2010, 02:10:42 PM »

I am finishing the setup of Mach and I am having a problem homing the machine.  When I home the axes it starts with the Z, moves the axist until it touches the limit switch then backs of a small amount, this seems just fine.  Then it moves the Y but when it touches the limit switch the machine just enters a e-stop condition, it never backs off the switch.  I set the debounce to 2000 but that didn't help.  Any ideas?