21
General Mach Discussion / Re: Problem homing when Autozero is disabled.
« on: April 28, 2010, 06:57:17 PM »
It seams Autozero and Verify are not the only issue here.
Trying to home the machine before you run a G-code works fine if autozero is checked.
Stopping a G-code and trying to home all hell brakes loose, same like disabling Autozero.
Can somebody duplicate this error too and suggest a solution ?
Thanks.
Trying to home the machine before you run a G-code works fine if autozero is checked.
Stopping a G-code and trying to home all hell brakes loose, same like disabling Autozero.
Can somebody duplicate this error too and suggest a solution ?
Thanks.