Guest
Show Posts
1
General Mach Discussion / Auto Squaring Not Working
« on: May 24, 2015, 01:30:03 AM »
I have been struggling with setting up auto squaring for some time now. I am just not able to get my X and A axis going the same direction during the Reference All Home function. I can job and cut things and run G-code just fine but homing the machine is not working. If I reverse one of the axis' in the homing menu then it breaks the normal jogging function. The same is true for the other way around. I would have thought that the homing menu would be separate from the normal operation menu but it seems when I make a change in one it changes the other.
My Home, ++ and -- switches are all on the same pin per axis, so X axis home, ++ and -- are the same pin, Y axis the same and then the A axis home and -- are are the third and final pin. I have tried all kinds of combinations in the Ports and Pins and the Homing/Limits menus and cannot get the thing to work.
I alos have Home SLave with Master Axis UNCHECKED and I made sure to have the A axis set to linear, not angular. I am running a Gecko G540 controller as well. Can anyone please help?
My Home, ++ and -- switches are all on the same pin per axis, so X axis home, ++ and -- are the same pin, Y axis the same and then the A axis home and -- are are the third and final pin. I have tried all kinds of combinations in the Ports and Pins and the Homing/Limits menus and cannot get the thing to work.
I alos have Home SLave with Master Axis UNCHECKED and I made sure to have the A axis set to linear, not angular. I am running a Gecko G540 controller as well. Can anyone please help?