Hello Guest it is December 05, 2021, 06:58:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - cnc4pete

Pages: 1
General Mach Discussion / Initial Speed control issue
« on: May 30, 2014, 08:25:23 AM »
Have a lathe with VFD drive running via PWM.
When initially launch Mach3 and after an S command M3 or M4 drive motor at max revs. Reissuing S and then M5 then M3 or M4 bring it back under proper control.
Assume this is a known bug, what is the fix?

VB and the development of wizards / Modifying lathe wizards
« on: August 12, 2010, 10:10:01 AM »
is there an easy way to modify the turning wizard? I run a slant bed lathe with in effect a rear turret. So have to edit the output of the wizard, change G02 for G03 and M3 for M4 and vis versa,

If not an easy way will a copy of visual studio 2002 do the job rather than 2003?


Pages: 1