Hello Guest it is March 28, 2020, 11:01:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - silverpuma

Pages: 1
1
General Mach Discussion / Re: Gage Block Height increments oneself
« on: September 25, 2014, 03:36:35 AM »
Ok ... i found the problem myself. 8)

I have conflicting OEM variables used in the range 1001 to 1009.
My variables monitors the micropump macro and  modbus inputs via brains.

Gage Block Height use a OEM Variable 1001 and Digitizing Wizard use OEM variables 1002 to 1007 !
This isue is not documented in the manuals. ::)

best regards
 fridolin

2
General Mach Discussion / Gage Block Height increments oneself
« on: September 24, 2014, 04:27:38 AM »
Hallo
Gage Block Height (in Offset Screen top/left) increments oneself.
The same value can i see in Digitizing Wizard "Width X" !
In Digitizing Wizard i can not enter "Width Y" and "Z travel" the values are overwritten onself.


In other respects my machine works very well since years.
Now i will use the Digitizing Wizard with my new XYZ probe.
I use Version R3.042.038

Could everyone help or give me a idea to isolate the problem ?

best regards :)
 fridolin

Pages: 1