Messages

61

General Mach Discussion / Re: g-code

« on: January 19, 2011, 10:13:38 AM »

i got it. when i save as i didnt have the the file type correct.i had it as cnc and not txt. the only other fault in the fanuc6 pp is all the ? in the beginning but im sure i can change that. gotta read up on it to see where the setup is. as you can tell im not to savy at this.

62

General Mach Discussion / g-code

« on: January 19, 2011, 07:43:31 AM »

when i load a g-code to mach i get plain box in window and no code. hit the edit and it comes up all garbled.. when i just open the file i see the code.im missing something simple. just cant put my finger on it.

63

Newfangled Solutions Mach3 Wizards / Re: user manual for nfs

« on: January 16, 2011, 09:45:49 AM »

i kinda figured that. not a big prob. the tutoral tells it all and is all good. is there any turtorials for the wizzards that come with mach3? just wondering.

64

Newfangled Solutions Mach3 Wizards / Re: user manual for nfs

« on: January 13, 2011, 02:41:46 PM »

well i guess not. ran some drastic #'s change for ramp angle to see the g-code. i like the results.

65

Newfangled Solutions Mach3 Wizards / user manual for nfs

« on: January 12, 2011, 05:09:07 PM »

i have version 2.75 manual. is there an update for i saw on page 23 circular pocket did not show ramp angle which is on the nfs 2.83

66

Newfangled Solutions Mach3 Wizards / Re: hex wizard

« on: January 09, 2011, 12:35:07 PM »

lol you sure got that right.

67

Newfangled Solutions Mach3 Wizards / Re: hex wizard

« on: January 09, 2011, 10:53:56 AM »

it is so easy to use the wizzards and i'm new to bobcad, so i'll just dive into it some more. need more practice for it is quite a learing curve.

68

Newfangled Solutions Mach3 Wizards / hex wizard

« on: January 09, 2011, 10:01:00 AM »

i am doing a job that has basic operations of milling but on 3 of the holes it requires a hex bolt to be flush with the surface. to do this i have to make another program in bobcad at the postions of the holes and let it be done. pain in the rear to put and take the parts just for this. is there somthing i'm missing in wizzards so that operation can be added to the main program? thanks tom

69

Newfangled Solutions Mach3 Wizards / Re: 2.83

« on: April 03, 2010, 07:16:05 PM »

thanks Ron

70

Newfangled Solutions Mach3 Wizards / 2.83

« on: April 01, 2010, 09:52:07 AM »

installed the 2.83 version and i have both in there. should i get rid of 2.79 or leave both in? just wondering if the two would fight against eachother.