Guest
Show Posts
11
General Mach Discussion / Motor outputs????
« on: March 09, 2010, 12:26:07 AM »
REALLY new to CNC in general and Mach3 in particular so bare with me a moment.
In the diagnostics screen, I am not seeing any "LED's" in the 'port pins current state' whether at rest or while jogging.
X,Y and Z are enabled in the 'ports and pins' cofig file.
Obviously, steppers aren't moving either (hobby cnc board) but are locked up when powered.
I've read through the manual but perhaps I've missed something.
Any help appreciated.
Alex in Texas
In the diagnostics screen, I am not seeing any "LED's" in the 'port pins current state' whether at rest or while jogging.
X,Y and Z are enabled in the 'ports and pins' cofig file.
Obviously, steppers aren't moving either (hobby cnc board) but are locked up when powered.
I've read through the manual but perhaps I've missed something.
Any help appreciated.
Alex in Texas