Hello Guest it is January 24, 2022, 09:35:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - GeorgeC

Pages: 1
Tutorials / Re: Video Tutorials for Mach
« on: February 28, 2010, 12:14:24 PM »
 Hello, I'm new to the forum and need a little help, I ran the drive test in the tutorial and it gave it a really good rating during the test. The problem I have is:
the line on the test, should it start at the top and work its way down to about 38 or start at that level when the test starts? there are also tight bunches of small wave that show up during the test, but the test program still give me an excellent rating? is that normal? I have tried the special driver bat file, but it stops the test from work, does not crash the system, the test just does nothing. I've looked for the program list talked about in the tutorial and have not been able to find it, is mach3 able to tune them out without disabling now? 

Thanks for the help

Pages: 1