1
General Mach Discussion / Re: Can't get motors to turn
« on: April 12, 2010, 04:09:16 PM »
I know it's an old theread but i'm currently have the same problem, the only diffrence is that my machine worked and then stopped after i re-installed mach3 - it was freezing the entire PC when started.
since the re-install i have no motor movmnet and exactly the same thing on the Paralell port pins,i get 4.34volts on all the pins all the time.
I guess i need to get another LPT card and give it a try too.
Eran
since the re-install i have no motor movmnet and exactly the same thing on the Paralell port pins,i get 4.34volts on all the pins all the time.
I guess i need to get another LPT card and give it a try too.
Eran