551
G-Code, CAD, and CAM discussions / Re: help with mach 3 not running at g coded feedrate
« on: September 13, 2013, 08:24:43 AM »
the next line goes back to 250
I'd seen this happen to from time to time with some of my runs, not sure why mach was doing it so I had to change my post to output feed rates on all g1 moves. Just thought it was another quirk with mach. Very exciting when it took off at rapid rate during what should have been a feed move. For awhile I had the rapid override set and turned on to a feed rate that would save me from cussing.
I'd seen this happen to from time to time with some of my runs, not sure why mach was doing it so I had to change my post to output feed rates on all g1 moves. Just thought it was another quirk with mach. Very exciting when it took off at rapid rate during what should have been a feed move. For awhile I had the rapid override set and turned on to a feed rate that would save me from cussing.