Messages

81

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 12:07:22 PM »

ok if i go 400 steps  on the distance 3'' or 76.2mm  machine can not overcome this distance, missing distance is 0.18 mm  I have to change the step to 401 then it is slightly more than 76.2mm . but if I  increases  the distance to 152.4 is 6'' is again a problem, step 401 is not enough I have to give 402 step and again the machine goes a little more

82

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 10:09:44 AM »

setup

83

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 10:05:24 AM »

setup

84

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 09:52:12 AM »

cut out with enabled backlash and it is the same  on X AXIS  is  40.65mm on Y axis  40.51mm

85

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 09:21:14 AM »

i  have gecko driver g540  motors is 200


200 x driver 10 macro steps is 2000 % pinch 5mm  give me 400 steps

86

General Mach Discussion / Re: mach3 ssetup

« on: September 12, 2011, 09:19:33 AM »

I do not have enabled backlash. I try to switch on and see what will be I'll give you a message

87

General Mach Discussion / mach3 ssetup

« on: September 11, 2011, 09:05:35 PM »

hi  I have   question my machine has backlash on Y axis 0.012mm on X axis 0.014mm  I cut a hole under Bearing 30mm everything is ok 29.95mm to 29.97mm dimensions

the part has to have dimension outside of 40mm x 40mm  but has 40.38mm on Y axis  and  on X axis 40.60mm  what's the problem?

I tried to set the machinery in different ways on 1/2 sherline , I tried to set the setup steps per unit but more worse comes out

88

General Mach Discussion / Re: mach 3 driver test program

« on: September 08, 2011, 09:44:17 AM »

the  mach 3  version  is ok  because  the mach3 in difrent  com  is working ok

89

General Mach Discussion / Re: mach 3 driver test program

« on: August 20, 2011, 09:10:22 PM »

no  only  that

90

General Mach Discussion / Re: mach 3 driver test program

« on: August 20, 2011, 09:07:17 PM »

in other  computer is  other screen  and is the same