1
General Mach Discussion / Z axis will not go down
« on: February 09, 2010, 11:09:02 AM »
Hi all I hope some one can help me with this..
when tuning I get a smoot run on my Z motor, up and down.
when joging I get a smoot run on my Z motor, up and down.
But when I try to run some code my Z motor will not go down
it just "humming".
It means that Z is humming and X and Y then run, then Z goes up, X and Y run Z humming and so on.
So Z is getting heiger and heiger up.
Hope you understand what I mean
Oliver
when tuning I get a smoot run on my Z motor, up and down.
when joging I get a smoot run on my Z motor, up and down.
But when I try to run some code my Z motor will not go down
it just "humming".
It means that Z is humming and X and Y then run, then Z goes up, X and Y run Z humming and so on.
So Z is getting heiger and heiger up.
Hope you understand what I mean
Oliver