Topics

21

CVI MachStdMill (MSM) / Mach3 General Config.

« on: September 06, 2010, 06:15:49 AM »

Hi Dave
I have been playing around a while now with your screen - all working great here. When I installed the first of the beta versions from you there was included instructions on how the set up the General Config page in Mach3. Now I can't find that in the later documentation, has it been dropped for the latter versions? or was I just imagining it in the first place?
Thanks
Steve

22

CVI MachStdMill (MSM) / The Brains

« on: July 20, 2010, 03:54:19 AM »

Hi Dave

I have been enjoying learning to use your new screen set - thank you for all the hard work that you have put into it. 

1: May I ask what the included brains are used for and do they have to be enabled for your screen to function as it should do? (Please excuse me if the answer is in your documentation - I haven't found mention of them yet).

2: My brain I use for feedrate and spindle speed overrides (borrowed from Hood) cause the MDI line to deactivate before I get a chance to type in it!  (It works through a PoKeys 55 and works fine on the other screens set I have used) Would you have any ideas why this may be happening - I have attached the brain concerned and I look forward to your comments.

Thanks
Steve