Hello Guest it is March 04, 2021, 05:27:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Truman

Pages: « 1 2
11
General Mach Discussion / Re: rebooting problem
« on: March 27, 2006, 12:01:05 PM »
I am pretty sure but say I didn't how would I remove everything to try again?

thank you

Rob

12
General Mach Discussion / Re: rebooting problem
« on: March 27, 2006, 12:56:10 AM »
Well I have run all or the optimising things on the list when I run a driver test it is great just like on video, when I try to do things within mach the computer reboots especially in motor tuning this has me stumped I even upgraded mach to the newest version thinking that a file might have been corrupted or something like that I really don't know what to do?

Rob

13
I love it but I havn't even figured out how to get my motors turning yet let alone change the screen how hard is it

14
LazyCam (Beta) / Re: LCAM ????
« on: March 24, 2006, 01:11:14 AM »
This might be a stupid question but when you do the updates to the program does it go into the 1.0 program on the artsoft site?

15
General Mach Discussion / Re: rebooting problem
« on: February 23, 2006, 11:48:28 AM »
the computer is a 1.13ghz dell the driver test does not reboot the system its when I try to do all the settings in particular when I try to scroll the page it is very strange to say the least I even tried the special driver with no change

16
General Mach Discussion / rebooting problem
« on: February 23, 2006, 01:44:01 AM »
Hi I have installed mach3 and watched the videos but when I go to configure mach to run my motors the computer reboots usually when I try to drag the scroll button this is really confusing can anyone help me?

thank you

Rob  ???

17
Newfangled Solutions Mach3 Wizards / Re: NFS Addins for Mach3Mill Questions
« on: February 21, 2006, 07:51:19 PM »
am I correct in assuming the NFS are in mach allready all you have to do is get a lisence for it?  might be a stupid question but I am still at the stage of figuring out the settings to get my motors turning

thank you

Rob

18
Newfangled Solutions Mach3 Wizards / Re: NFS Addins for Mach3Mill Questions
« on: February 21, 2006, 07:47:38 PM »
Is the newest version 1.84?

Pages: « 1 2