Hello Guest it is October 16, 2019, 04:40:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - blake374

Pages: « 1 2
11
no one?

12
Hello

I was planning on generating g-code with deskcnc to use in Mach3 to run my cnc hotwire.  I am un sure of how I am going to create the shapes that I want to cut and use them with the software.  I will be creating fairly simple shapes, but I will to be need to able to resize portions of the shape by an 1/8th of an inch.  It might be called offsetting the shape but I don't know because I am new! ;D  Thanks a bunch for reading and any advice you could give would be great!

Blake

Pages: « 1 2