1
Post Processors / Re: Mastercam 2017 Post Processor
« on: October 20, 2017, 11:22:39 AM »
The UpdatePost.dll seemed to work properly and did this for both the sharedMcam2017\Posts and sharedMcam2017\Posts\Mill folders. Not sure what you mean by "put the post into your machine definition". If this is under the Machine tab in MC2017, I show nothing for for the Boss control.
Would you mind posting a more detailed procedure for those of us computer challenged.
Thanks much.
Would you mind posting a more detailed procedure for those of us computer challenged.
Thanks much.