Hello Guest it is June 13, 2024, 08:58:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jbmachine

Pages: 1
General Mach Discussion / Re: Mach3 works BUT
« on: November 10, 2011, 08:16:46 PM »
Yea but if no new tool is added and It was saved it should come back up

I think it may be pulling up a backed up xml file - can those be deleted except for the latest one??

General Mach Discussion / Mach3 works BUT
« on: November 10, 2011, 03:22:49 PM »
I have mach3 latest build running on a cnc mill upgrade - strange thing when mach3 loads for the first time some times the saved offset is correct and the tool table is correct and sometimes they are off a restart and they are fine
when things are wacky, I am missing "new" tools that were setup -

any ideas


Pages: 1