Messages

11

General Mach Discussion / Re: Mach3 crashes after File>Load Gcode command

« on: October 23, 2011, 08:29:52 AM »

Crashes on every file load from the command File>Load Gcode.

I tried having SheetCam load a file directly and it crashed while SheetCam opening. Is there a debug window or log?

I am reloading windows today...

12

General Mach Discussion / Re: Mach3 crashes after File>Load Gcode command

« on: October 22, 2011, 10:11:28 PM »

The plasma is not turned on at the moment. I did get some progress... I used the "open recent" Gcode command and I was able to load all the recent files and run them without issue. It only seems to be the File> Load Gcode that buggers things up.

13

General Mach Discussion / Re: Mach3 crashes after File>Load Gcode command

« on: October 22, 2011, 09:52:12 PM »

No new programs. This is a small plasma table that rarely sees use. I did upgrade the RAM but it ran fine when I last used it.

I just tried the driver. No love. In fact, it would not launch. It froze at the splash screen.

I will try and reload the OS tomorrow...

14

General Mach Discussion / Re: Mach3 crashes after File>Load Gcode command

« on: October 22, 2011, 09:23:52 PM »

That got me a little bit farther... I ran the driver test, opened Mach and went to File>Load Gcode and the this time the file browser window came up instead of crashing. I selected the .tap, clicked open and it crashed again. I have to reboot after each crash. The driver refuses to close. Any other ideas?

15

General Mach Discussion / Mach3 crashes after File>Load Gcode command

« on: October 22, 2011, 08:54:17 PM »

Any help would be appreciated. First time I used this machine in about 3 months. Ran fine without any issues before... Its a XP desktop with over 1 GB of memory. I usually load code from a thumb drive... the computer is not on a network.

16

General Mach Discussion / Tool path pan and zoom?

« on: February 10, 2010, 10:20:06 AM »

How do you zoom and pan your drawing in the toolpath window? What are the keyboard shortcuts for this?