1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: February 04, 2010, 08:27:56 PM »
My name is Kane
I am new to this form and I am working on and three axes mill.
I have mach3 software and a HobbyCNC EZ Driver Board
Frame size: NEMA 23
Holding torque: 136 oz-in
Voltage: 3.2 VDC
Current: 2 A
Step Angle: 1.8° (200 steps/rev)
Leads: 6 wires
Wiring: Unipolar
stepper motors
And I could use a lot of help to create and configuration file
I have a lot to learn?
Thank you for reading Kane
I am new to this form and I am working on and three axes mill.
I have mach3 software and a HobbyCNC EZ Driver Board
Frame size: NEMA 23
Holding torque: 136 oz-in
Voltage: 3.2 VDC
Current: 2 A
Step Angle: 1.8° (200 steps/rev)
Leads: 6 wires
Wiring: Unipolar
stepper motors
And I could use a lot of help to create and configuration file
I have a lot to learn?
Thank you for reading Kane