11
General Mach Discussion / Re: different behavior in motor setup screen and run mode
« on: January 07, 2010, 02:41:44 AM »
Sorry, I think I have the same problem.
Configure the machine to make a big square 150x90, but in doing small 30x30 the result is 29.7 x29, 7
Configured for the correct exit 30x30 small and large is the result of 151x91
This problem is the same as yours. It may be because the PC is slow
My machine is a Zenbot with Mach3
Configure the machine to make a big square 150x90, but in doing small 30x30 the result is 29.7 x29, 7
Configured for the correct exit 30x30 small and large is the result of 151x91
This problem is the same as yours. It may be because the PC is slow
My machine is a Zenbot with Mach3