Hello Guest it is May 25, 2024, 02:15:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - geast

Pages: 1
General Mach Discussion / Work offset not remembered
« on: July 04, 2019, 02:36:00 AM »
I notice that when i work to a work offset, like G56, or whatever except G54, and shut down normally the Mach3, when i startup again the work offset is always G54. In general config everything is checked as persist. Is there a way to accomplish that the last working work offset will be remembered, and when i startup the mach3 it will be in G57 for example and that i don't have to switch to this work offset every time i startup?
Any help will be appreciated.

VB and the development of wizards / Internal error <SetUserDRO>
« on: February 06, 2014, 03:24:15 AM »
A very strange error only in windows XP

I write a simple macro in windows XP

Dim  Y As Integer
Dim A  As Double

Y = 1000
A = 1234

aaa= GetUserDRO(1000)


and when i executed in windows vista everything is ok, but when in XP i have an error Internal error <SetUserDRO>.
Please check the attached pictures

Hello everybody.
I install a dynomotion kflop+kanalog boards together with three analog servo drives. The drives takes +-10V and have incremental encoder for feedback.
The X axis has a slave axis A and it is so configured  on mach. Everything works fine when i do cont.jog from mach or a G command G0 Xsomething to the X axis.
The problem is that when i do a step jog or when i execute a g command G01 Xsomething then the slave axis A does not work. Only the X axis rotate.
Can anybody help?

VB and the development of wizards / XML file reader
« on: January 26, 2013, 12:14:25 PM »
Hello everyone.

I want to read some data stored in a *.xml file into some oemdro's, or other mach's variables, by using a macro.
Has anybody do it before?
I know there is the Msxml.dll from microsoft, is there any way to use in cypress vbscript language?
Any help will be appreciated.

General Mach Discussion / Torch volts control
« on: April 18, 2011, 01:49:25 AM »
Hello everybody.
Does anybody knows what the option in Config->Ports & pins->Spindle setup->Torch volts control does?
In the installation manual is nothing writen.
Any help will be appreciated. 

General Mach Discussion / Plasma tube cutting
« on: December 20, 2010, 05:33:22 PM »
Hello everyone
I'm building a flatbed plasma cutting machine, and i want to be able to cut holes on a tube, also.
The tube will be parallel to the Y axis and rotated probably from axis A with an extra servo driver/motor.
My question is how to configure mach3 to use either axis A or X depending if i want to cut a hole on a tube surface or just a normal sheet metal X,Y plane.
Also i need somehow to give the information to mach3 of the diameter of the tube in order to calculate the right feedrate and the steps per inch/mm for every different tube diameter i will cut.
Any help will be appreciated.

General Mach Discussion / Pins 2 & 3 dont work.
« on: April 10, 2010, 04:41:55 PM »
Hi everybody.
I can't get the output pins 2 & 3 make them work.
I try to set them in the port and pins menu, as motor X pulse & direction outputs but nothing happens.
If i try the same at pins 4 and 5 or 6 and 7 everything works fine.
What is so special with this to pins 2&3 that they don't operate?
Has anyone any ideas?

Pages: 1