Messages

21

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 30, 2009, 03:01:04 PM »

Hood
Yes I got that M1 led to light up now too.
Ok now is there a standard way to assign the pins in Mach three for a controller?
Thanks jolyon

22

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 04:20:28 PM »

Thanks a lot for all your help this evening! I know it must take a lot of patience dealing with us noobs.

23

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 04:04:30 PM »

Has This worked? I can try and take better shots if you need more info.

24

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:55:19 PM »

Have captured image but cant figure out how to attach it. It offers me the option of attaching to email however.

25

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:41:56 PM »

Duh sorry this is all very new to me.. How do I take snapshot of screen and attach?

26

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:34:24 PM »

even though i haven't assigned any pin numbers?!

27

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:32:46 PM »

okay no joy with pin 12, however i have enabled the inputs to port 1 and can seem to switch leds on and off...

28

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:20:51 PM »

okay when i dont check active low i cannot reset until i togle to active low (the program offers to do this for me). However I dont seem to get any response shorting out pin 12 to pin 25?

29

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:08:29 PM »

I have checked box for enable x home, port 1, pin 12, do i have to check active low or emulated?

30

General Mach Discussion / Re: 1-Port Parallel PCI Card

« on: November 29, 2009, 03:03:19 PM »

Okay I'm looking at the inputs section on ports and pins but I dont see X limit only x ++, x --, x home?