Hello Guest it is March 28, 2024, 11:59:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - noyloj

Pages: « 1 2 3 4 »
11
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 05:04:07 PM »
looked where you said in components ports parallel and nothing there!
By the way what is an xml? sorry!

12
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:58:42 PM »
they are lighting up the amber leds for M1 M2 and M3

13
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:49:44 PM »
Hood mis type sorry! should read:- orientated so that 13 pins on top row and twelve beneath

14
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:45:12 PM »
yes x enabled yes x pin 2 and 3 yes ports for step and dir configured as port 1
Don't have mach manual but i'm looking at female connector (ie one without pins)
orientated 30 that 13 pins are on top row and twelve beneath
pin 3 is 3rd from right on top row
pin 25 is bottom left bottom row
is that correct?

15
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:34:11 PM »
also box says PCI card I have 'supports SPP, EPP, ECP'
although instuctions give no clue as to how to switch!
Thanks Jolyon

16
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:20:31 PM »
but no output on voltmeter..

17
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:20:02 PM »
ok got it arrow keys..

18
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:17:29 PM »
hood dumb question no 65
How do i jog?

19
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 04:05:00 PM »
Heya Hood

Ok I tried running a g code program (roadrunner) and watched from the diagnostic screen as it scrolled thru.
Nothing on leds?
Should I not see something coming on and off?
Also tried plugging parallel connection into micro mill controller and nothing.
Ok I don't actually know machine works but..

Whats EPP ECP how do I switch too?

Thanks Jolyon

20
General Mach Discussion / Re: 1-Port Parallel PCI Card
« on: December 01, 2009, 03:26:41 PM »
Okay rewind...
I had hoped that the leds I got to work directly corresponded to the parallel port pins that I was shorting.
No such luck.
I think that the address in Device manager under PCI ECP parallel port (LPT 3) is for the PCI card maybe?
If this is the case then how can I find the proper parallel port address?
On the plus side I think I found which pins will ultimately correspond to the controller functions such as x dir x step etc.
Thanks Jolyon

Pages: « 1 2 3 4 »