1
General Mach Discussion / Stepper direction one way only!!!!!!!
« on: July 10, 2014, 10:06:45 AM »
While machining the x axis freaked out and kept going in the same direction. When I stopped the machine I tried moving the table and the x axis would only go in one direction whether I pressed the right or left arrow. This happened 2 years ago and vanished when I updated the software. The problem has reappeared again.
Is it a Mach3 problem or controller problem or a Microsoft problem ? Or none of the above?
Mach3 currently has version R3.043.067
Is it a Mach3 problem or controller problem or a Microsoft problem ? Or none of the above?
Mach3 currently has version R3.043.067