Messages

1

General Mach Discussion / Re: Z late getting to final depth

« on: November 20, 2009, 11:05:56 PM »

I did change it from CV mode but cut was real jerky. I've been getting the G codes via Lazycam. Could it be a setting in LC?
Joe

2

General Mach Discussion / Z late getting to final depth

« on: November 20, 2009, 12:01:12 PM »

Hi, Let me start out saying I'm new to Mach. I have just finished building my table and have a problem. Whenever I start to make a cut my Z axis doesn't get to it's final depth before x and y start to move. It will get there, but the first part of the cut is shallow.
Joe