Hello Guest it is January 23, 2022, 05:22:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Loeilduvert

Pages: 1
General Mach Discussion / Re: General Profile Setup
« on: November 18, 2009, 02:02:34 PM »
Thanks for the advice.
Emailed Super-tech to see if they have an XML file. Will see if that solves the issue.
I have documentation of the pinouts, which I have programed in just not sure if I have all the other settings right.
How would I "have a direct link to control documentation". Is that a matter of getting you an XML of my settings? I think I saw you explain to somone else how to do that on this board I can look that up.

General Mach Discussion / General Profile Setup
« on: November 17, 2009, 12:26:36 PM »
I am running servos on a Taig through a EMC-XYZ-GSX Servo Motor controller which was bought from supertech.com
I have gotten the motors to spin but am not sure that I have the profile set up perfectly. Is there any way I could get the XML file and load the correct one? Or should I use an XML that is posted somewhere? I am sorry if reiterating someone else's question just unsure if there is a profile that would be specific to this configuration. 
I set up the mill using the tutorial and it didn't spin, my coworker fiddled with the setting for a while and now they spin with the arrow keys but he said he is not sure he set it up perfectly and to ask for an XML file so I could load correct settings.
Thanks for the help. Again sorry if I am missing a post about exactly this.

Pages: 1